Full text: Commissions III and IV (Part 5)

  
The standard errors of the coordinates x and y are then obtained as 
y 
— 
m, = Sy J Qu (38) 
m, ES $9 y, (39) 
sy is the standard error of the image coordinate measurements (with 
minor approximation). The expressions (38) and (39) are graphically 
demonstrated in the diagrams 3 and 4 for s, — 1. 
The magnitude of s, depends upon a great number of factors, as for 
instance, the negative material (film or plates), the quality of the lens, 
the accuracy of the actual measuring device ete. For wide angle film 
cameras c = 150 mm and high precision measuring devices the magnitude 
of s, is about 0,01 mm. 
In the same way the error propagation and distribution can be in- 
vestigated for other positions of the control points. In diagrams 5 and 
6 the distribution of the standard errors is demonstrated for another 
position of the control points. If more than two control points are given 
there will be discrepancies in the control points in connection with the 
coordinate transformation. In such a case some condition must be 
specified for the adjustment of discrepancies. The simplest and most 
convenient condition is that after the transformation the square sum of 
the discrepancies in the control points shall become a minimum. After 
introducing this condition and treating the discrepancies as functions 
of the basic measurements the error propagation and distribution can 
be determined as above. This method was used by HALLERT 1956. 
1.16. Systematic errors of the intersected coordinates due to inclinations of the 
photographs 
We shall assume the image coordinates to have been measured in 
coordinate systems, the origins of which are located in the principal 
points. The intersections were then computed according to formulae 
(1) and (2) above. If, however, the inclinations of the photographs were 
94 €, Q9 05, respectively, and if the elevation differences on the ground 
were small in comparison with the flying altitude, the origins of the 
image coordinate systems should have been chosen in the isocenters of 
the photographs, see fig. 3. The coordinate systems, the origins of 
which are located in the principal points, are denoted (x')(y') and 
(x") (y") respectively. The corresponding coordinate systems, the 
origins of which are located in the isocenters, are denoted z'y' and 
x" y" respectively. The image coordinates of the isocenters are 
9 
  
  
  
  
  
  
  
  
  
 
	        
Waiting...

Note to user

Dear user,

In response to current developments in the web technology used by the Goobi viewer, the software no longer supports your browser.

Please use one of the following browsers to display this page correctly.

Thank you.