Full text: Proceedings, XXth congress (Part 7)

004 
  
The 
cate 
n of 
onse 
| for 
'rted 
thod 
ising 
d in 
nade 
' the 
data 
rmal 
veen 
Ithus 
soll 
ative 
21 by 
dard 
cel, 
area. 
with 
ever, 
rated 
soil 
ctrum 
with 
iat are 
ire 2); 
meters 
nsitive 
pheric 
te tool 
> most 
ophyll 
inuous 
"'ASI-2 
| width 
cessing 
  
  
International Archives of the Photogrammetry, Remote Sensing and Spatial Information Sciences, Vol XXXV, Part B7. Istanbul 2004 
techniques were then applied to the airborne CASI-2 imagery 
acquired for the Houghton-le-Spring test site during 2002 and 
2003. 
4.1 Red edge position 
The red edge is defined as the ramp in green vegetation 
reflectance between the red and near infrared wavelengths, 
between 670 nm and 780 nm (Figure 3). It is related to the 
concentration of chlorophyll in the vegetation canopy (Miller et 
al, 1990) and may be characterised by the position of 
maximum slope or Red Edge Position (REP). The slope and 
position of the red edge change under stress conditions, with the 
REP moving towards shorter wavelengths in response to 
senescence (Rock et al, 1988) The REP is therefore an 
appropriate tool for investigating the effect of subsidence on 
vegetation. 
reflectance (%) 
507 
blue green red near infra red 
45: 
40 1 A 
" / 
30: / 
2 
un 
1 
| red edge 
  
  
0 | TTE T T T T 7 
450 550 650 750 850 950 
wavelength (nm) 
Figure 3. Typical vegetation reflectance spectrum in the 
CASI-2 spectral range. The red edge is highlighted. 
A method was required to estimate the REP from the discrete 
bands that bracket the red edge in the CASI-2 vegetation 
bandset. Several methods are available for estimating the REP 
from discontinuous data, each of which has it advocates and 
detractors. Two methods were assessed; Guyot and Baret 
(1988) method and Lagrangian interpolation (Dawson and 
Curran, 1998). The former method, as implemented by Clevers 
et al. (2001) is computationally simple but approximated the red 
edge to a straight line and is therefore less sensitive to shifts in 
the REP. The Lagrangian method involves calculation of the 
first derivative and the fitting of a polynomial function in order 
to estimate the REP. Although it is computationally more 
intensive it theoretically provides a more accurate estimate of 
the REP. 
Accurate measurement of the REP can be made from the ASD 
spectra by derivative analysis and the position compared to that 
calculated using the Guyot and Baret, and Lagrangian methods 
applied to the simulated CASI-2 data set. Clevers et al. (2001) 
noted the possibility of artefacts in the calculated REP where 
more than one maximum is present in the first derivative. This 
phenomena has been noted in ASD spectra from the test site 
and requires further investigation. 
717 
The REP has indicated species changes in areas affected by 
subsidence and shifts in REP have also been noted within 
species in affected areas. 
4.2 Chlorophyll absorption feature 
The chlorophyll absorption feature is found between the red 
peak and the red edge of the vegetation reflectance spectrum. 
Increases in canopy chlorophyll result in a minor deepening and 
major broadening of this feature (Banninger, 1991). Continuum 
removal, which is widely used in geological spectral studies, is 
a normalisation technique that emphasises the wavelength and 
depth of individual absorption features (Clark and Roush, 
1984). The chlorophyll absorption feature is described by the 
reflectance values of ten CASI-2 bands between 450 nm and 
750 nm. 
reflectance (%) 
  
  
  
50 - 
45 17 
40 - y 
35 A 
E 
| 7 / 
30 4 continuum // / 
2s 7 / 
/ 
20. / 
15 / 
10 - of / chlorophyll 
/ / absorption 
dient, T 
31 nian cu, feature 
oL : : ien 
450 550 650 750 850 
wavelength (nm) 
normalised 
reflectance 
10 normalised continuum 
. he pass 
/ 
/ 
/ 
/ 
/ 
\ FWHM | 
=—-> 
depth 
05 ept 
/ 
\ 
\ 
X 
a | | 
  
  
  
| position of minimum 
1 
550 750 
wavelength (nm) 
Figure 4. Continuum removal of the chlorophyll absorption 
feature and parameters. 
The continuum is a convex hull connecting the maxima at 550 
nm and 750 nm, defined by CASI-2 band positions (Figure 4). 
Continuum removed values for each band are obtained by 
dividing the reflectance value for each band by the convex hull 
value, resulting in values between zero and one. The discrete 
band positions of the CASI-2 dictate that the position of the 
 
	        
Waiting...

Note to user

Dear user,

In response to current developments in the web technology used by the Goobi viewer, the software no longer supports your browser.

Please use one of the following browsers to display this page correctly.

Thank you.