10
To obtain the described punching the following programme is used in the EK 5:
= FIG 876 PT 543 BL BL T AB 6543 PT 21 BL BL T AB
n.° of identification x
6543 PT 21 BL BL T AB 4321 BL BL T AB AB
~~y
The connection = commands the punching of the signals cr If and the connections
TAB are destined only to the typewriter.
To the separation of the general ribon into more than one, it is necessary to punch,
after each parcial ribon the signal 24 (.
3.2 — AUXILIARY RIBON
All the data, necessary to the adjustment which are not to be in the general ribon,
are punched in this ribon.
Owing to the fact that the planimetric adjustment is completely different wether
there are or not intermediary controls, two different programmes are prepared,
one for each case.
In both programmes the height adjustment can be performed in two ways, accord
ing to the introduction or not introduction of the statoscope values.
The first is for aerial levelling, performed with bz = o, having statoscope data.
The second is used when aerial levelling is performed with bz = o and there are no
statoscope data or these are introduced in the autograph.
The first way still permits the correction of mistakes by their introduction in the
autograph.
3.2.1 — PROGRAMME AT-1
This programme performs the adjustment of strips without intermediary controls.
The following data must be punched in the auxiliary ribon.
— Indicative of the type of height adjustment
0 — with introduction of statoscope data
1 — without introduction of statoscope data