×

You are using an outdated browser that does not fully support the intranda viewer.
As a result, some pages may not be displayed correctly.

We recommend you use one of the following browsers:

Full text

Title
Mesures physiques et signatures en télédétection

ABSTRACT:
The modeling of the directional reflectance of vegetation canopies and vegetation-covered surfaces has been a
highly active field in remote sensing within the past decade. Recent developments have refined physical mod
els of directional reflectance; added coupled atmospheric models; included invertible models; and produced
new, semiempirical models. Although models are well-formulated, more validation datasets are needed. For
the EOS era, invertible models that provide useful information for global change studies are most desirable.
KEY WORDS: BRDF Models, Vegetation Reflectance, Global Change, Earth Observing System
1- INTRODUCTION
1.1. Anisotropic Reflectance
The earth's surface scatters radiation anisotropically, especially at the shorter wavelengths that characterize
solar irradiance. Surface scattering is described by the bidirectional reflectance distribution function (BRDF)
(Nicodemus, 1977), which specifies the behavior of surface scattering at a particular wavelength as a function
of illumination and viewing positions within the hemisphere. The scattering behavior of a surface also
determines its spectral albedo—the ratio of radiant energy flux within a particular waveband that is scattered
upward and away from the surface in all directions to the downwelling irradiance in that waveband incident
upon the surface. If the BRDF is known, the albedo can be derived given knowledge of the angular distribu
tion of incoming irradiance.
The anisotropic reflectance of the earth's surface provides an opportunity to infer information about
the physical parameters of the surface cover that produce the anisotropic effect. In the case of vegetation-cov
ered surfaces, this anisotropy derives largely from such factors as the scattering behavior of leaf surfaces; the
distribution of leaf surface orientations; the size and spacing of leaves; the clumping of leaf area into individual
plant crowns; the size and shape of plant crowns; the arrangement of plant crowns on the surface; and the
anisotropic reflectance of the underlying layer of soil or ground cover.
Physical models of the scattering behavior of vegetated surfaces that include such factors can, under
proper circumstances, be inverted from measurements of surface radiance to infer parameters that are of value
in studies of global change and global ecosystem dynamics. Such parameters include the amount of leaf scat
tering material (leaf area index), which is useful in global ecological monitoring of ecosystem piimary produc
tivity and also governs the transfer of latent heat through transpiration in surface energy balance studies; hemi
spherical albedo, which describes the amount of radiation reflected (and therefore absorbed) by the
soil/vegetation layer and is useful in surface energy balance studies and global climate modeling; and plant size
and spacing, which condition surface roughness length and therefore turbulent energy flux and mass transfer
as specified within global climate models.
Inference of these types of physical parameters requires inversion of a physical model of canopy
reflectance, which in turn requires a suite of reflectance measurements of the vegetated surface obtained from
different viewing positions. Since the acquisition of such measurements over large areas is possible by remote
sensing with airborne or spacebome instruments, this possibility has inspired the development during the past
decade of the field of plant canopy directional reflectance modeling.
Note also that the anisotropic reflectance of earth surfaces presents a problem for inference from
remotely-sensed images. Reflectance anisotropy means that radiance measurements of the same surface cover
will vary with viewing position, which can lead to incorrect scene inference, especially in the case of multidate
satellite imagery in which views are acquired under different geometries. Remote determination of the surface
BRDF allows correction for these view angle effects through such methods as normalizing individual mea
surements to a standard viewing position, or integrating the BRDF to yield a hemispherical spectral albedo
f hat is not dependent on viewing direction.